GENERAL
•  

1.01 Summary and Introduction

•  

1.02 Submittals

•  

1.03 Material Acquisition - Lead Times - Storage - Handling - Delivery

    PRODUCTS
•  

2.01 General Description

•  

2.02 Material Content

•  

2.03 Provision and Fabrication Review

•  

2.04 Finishes Packaging

•  

2.05 Examination & Inspections

•  

2.06 Fabrication Venue

•  

2.07 Site Verification of Installation Conditions

•  

2.08 Material Mill Certification

    EXECUTION
•  

3.01 Installation Scheduling

•  

3.02 Installation Work Hours

•  

3.03 Building Corner Treatments

•  

 3.11 Exclusion

•  

3.04 Maintenance & Inspection

•  

3.05 Safety Precautions

•  

3.06 Product Performance - Design for Normal condition

•  

3.07 Heat Stress, Metal Deformation, Warping and Twisting

•  

3.08 Labor Code - Prevailing Wages

•  

3.09 Caulking/Flashing - Sealing

•  

3.10 Methods of Installation

•  

 3.12 Permits

•  

 3.12 Contracts and Purchase Orders

    WARRANTY
    SPECIFICATIONS OF THE ILLUSTRATED STYLES
    TYPICAL SPECIFICATIONS INTERNET SPECS

3.01 Installation Scheduling

When Installation by B&C is Contractual, General Contractor must coordinate in accord with B&C’s fabrication schedule contained in the accompanying dated letter with these submissions. Measurement shown on submissions are subject to field verification or Architects changes before fabrication can proceed and usually shows measurements taken from original plans. As a condition of submission and acceptance special attention should be given by the Contractor and Architect to the dated introductory letter accompanying these submittals which clearly indicates a production time schedule for B&C to fabricate and ship .By approving these submissions Contractor agrees to this schedule and the terms and accepts the design of the units and to coordinate his work accordingly to B&C’s schedule and provide and facilitate available conditions such as payments to accelerate check measuring opportunity and avoid production delays. Not with standing anything to the contrary contained within any contract these submissions when approved become definitive of B&C’s intent and buyers agreed scope of B&C’s work

 As a condition of issue of these specifications by B & C and the Contractors acceptance, Contractor agrees to give  B & C at least (7) days written and formal notification followed by a phone call that a project is ready to field measure. There after to allow B & C to take the number of weeks shown on B & C’s submittal letter to Fabricate and to Install. Contractor agrees  not to create conditions which make the hire of expensive equipment necessity to install or conditions impossible or formerly request installation before B & C’s schedule will permit.

A. Mobilization- B & C propose and have contracted for a single “mobilization and continuous uninterrupted installation” on this project it is specifically agreed as a condition of issue and acceptance of these submissions that if an interruption or additional mobilizations and installations are required through no fault of B & C to the single mobilization proposed that Contractor will pay additional moneys for delivery and re-hire of lifting equipment, and manpower (see 1.04 A)

Google Analytics Alternative Clicky